When preparing the fiber optic cabling for a long installation, it is recommended that the cable is rolled from the spool to form a “Figure 8” on the ground. How To Figure 8 Cable for Intermediate Pulls in OSP Installations On very long OSP runs (farther than approximately 2. 5 miles or 4 kilometers), it may be necessary to use an automated fiber puller at intermediate point (s) for a continuous pull or pull from the middle out to both ends (midspan. Since a pulling rope with a small diameter may cut the inner duct when being pulled, it is necessary to lubricate the pulling rope. In addition, wire mesh pulling grip and breakaway swivel are recommended as well during cable pulls. This technique puts a half twist. Cable knots are a type of knot used to join two cables or ropes together, or to attach a cable to a post, rail, or other fixed point. - SCOPE This document covers all the activities usually performed by PRYSMIAN for on-site installation of OPGW fibre optic cables, including transport, installation, accessory assembly, verification of optical.
